We're Always Here To Help
Reach out to us through any of these support channels
Retractable Through Table Cardioid Condenser Boundary Layer Microphone.
Technical | |
Application | Designed for superior quality voice reproduction required in venues such as boardrooms,conferencing,court rooms and other such venues. |
Type | Condenser (back electret) |
Polar Pattern | Cardioid |
Frequency Response | 50Hz - 18 KHz |
Sensitivity | -37dB +/- 3dB @ 1 KHz (0dB = 1 V/Pa) |
Impedance | 200 Ohms |
S/N Ratio | 69dB(A) |
Maximum Sound Pressure Level | 120db at 1KHz 1% T.H.D. |
Power Requirements | 9 - 48 volts phantom power |
Termination | Open ended |
Wiring connections | Black 2 core + screen Red Conductor Phase + White Conductor Phase - Screen Ground Grey 2 core + screen/shield used for identification switch no polarity or power required screen not used. |
Finish | Black Nextel® or Satin Nickel. |
Dimensions | Hole cut out diameter 30mm (1.18") Surface height 3mm (0.2"), extended height 15mm (0.6") surface diameter 36mm (1.4"). |
Weight | 384grms (13.55 oz) |
Architects and engineer specifications | The Microphone is a low profile boundary layer through table design with a cardioid polar pattern. The Microphone is push activated for both UP and Down positions leaving only 3mm (0.12") protruding above the surface when in the retracted position. The Microphone is engineered in high quality brass for long life and smooth action. The Microphone has an integral eletronic module which requires a 9 - 48 volt phantom power supply. The Phantom Power Adaptor includes filters which will eliminate all cellular frequencies (GSM/2G, 3G, 4G & 5G). Impedance 200 Ohms Frequency 50Hz - 18HZ Sensitivity -37 ± 3dB @ 1 KHz (0db = 1V/Pa) THD 120dB is no greater than 1% The Microphone connections: Audio a 2 metre (6.6ft) open ended 2 core and screen cable. The switch is a gray 2 core and screen the screen is not used. The switch is not designed as an on/off audio switch and is only for use via a DSP system for muting when the microphone is in the retracted position. Finish: Black Nextel® or Satin Nickel. |